ポスト #1 · 2012-09-13 03:55:07amにポスト 13.1年前
 paksunghoon | |
|---|---|
 |
Member |
| 1 ポスト | |
| Not Set | |
| Reg. 2012-09-13 | |
I have been searching for hours and well I can't find a detailed answer. I have no control box for my Cobalt Flux I just picked up, but I do have a DDRGAME control box and pad. I want to use the wiring that is in the DDRGAME pad's 15 pin connector and swap it over onto the Cobalt Flux that way I can just use the DDRGAME control box. What's the procedure to doing this swap? Or if there is a easier way. I don't want to make one out of a generic usb controller, I want to use my DDRGAME control box that I already have. Thanks for any reponses given.
ポスト #2 · 2012-09-22 12:04:27pmにポスト 13年前
| jaybay | |
|---|---|
|
Member |
| 1 ポスト | |
| Not Set | |
| Reg. 2012-09-17 | |
Hope theres an answer for this!
ポスト #3 · 2012-10-04 05:34:35pmにポスト 13年前
| 8ftmetalhead | |
|---|---|
 |
Member |
| 422 ポスト | |
 | |
| Reg. 2010-08-17 | |
| "Oh god what I have dooooone?!" | |
determine pinout, wire up a custom cable.
Funnily enough I'm just answering this exact question here:
http://r21freak.com/phpbb3/viewtopic.php?f=38&t=21833&p=335426#p335426
and it's been asked many times previously. If I ever find an actual cobalt flux pinout, I'm gonna post that shit in every topic on this subject because it gets asked so much but just far enough apart to make it look like it's never been asked before.
blah.
Funnily enough I'm just answering this exact question here:
http://r21freak.com/phpbb3/viewtopic.php?f=38&t=21833&p=335426#p335426
and it's been asked many times previously. If I ever find an actual cobalt flux pinout, I'm gonna post that shit in every topic on this subject because it gets asked so much but just far enough apart to make it look like it's never been asked before.
blah.